Questions? Call Steve (360) 923-1012

HUCK A206-375 POWERIG GUN RIVETER INSTALLATION TOOL

---

Huck 206-375 Powerig Hydraulic Installation Tool in good working condition.  Pulls Huck Huckbolts as used in truck trailer repair and industrial assembly work.  USES POWERIG NOSES AND PULLES MOST HUCK FACTNERS UP TO ABOUT 3/8".   Manual included. Nose excluded, call for info or see my other auctions.

Specifications:

Power source ……………Huck POWERIG Hydraulic Unit

PULL pressure…………….5400-5700 psi 37200-39300 kPa

RETURN pressure………………2200-2400 psi 15200-16500 kPa

Maximum pinbreak………………….9700 lbf 43,148 N

 

Model No.   Length   Width   Height Weight
206-375   4.5 in.  1.75 in. 3.25 in.  3.37 lbs.
             115 mm   43.5 mm   83mm 1   .5 kg

Description:

Huck Models A206-375 and 206-375 Hydraulic Installation Tools install various fasteners. These light-weight and compact mini- tools, with their offset nose assemblies, have been specially designed for limited clearance areas.

Tools are powered by Huck POWERIG® Hydraulic Units, or equivalent. These tools are designed to operate on 5400 to 5700 psi PULL pressure and 2200 to 2400 psi RETURN pressure as supplied by your hydraulic unit.  

A206-375 is an air triggered tool to be used with Huck Models 956 and 970 POWERIG Hydraulic Units, or equivalent.  206-375 is an electric triggered tool designed for use with Models 913H, 918 and 940 POWERIG Hydraulic Units, or equivalent. Use the correct nose assembly for your fastener. Each 206-375 Tool is complete with hydraulic hoses, couplings and control trigger assembly (air or electric). Tool consists of a cylinder assembly and a piston assembly. Piston has a Dump Valve to relieve hydraulic pressure at end of PULL stroke. Piston rod is off-center to the centerline of piston. Tool clearance is increased by having an off-center piston assembly. An offset nose assembly enhances the tool’s built-in clearance. This provides maximum clearance obtainable. A nose assembly is attached to the tool’s piston rod using the nose assembly’s draw bar. An anvil holder stop limits nose assembly rotation to 80 degrees. Included with each tool is an extra Dump Valve. This Valve is used when a longstroke tool is required. Remove Stroke Limiter and install extra Valve (flats to rear of tool). Hoses may be installed in bottom of cylinder or out the back of cylinder, as application requires. After removing hoses, move pipe plugs to hose ports, then reinstall hoses.

I am a Tool Hound and am always finding unique and different tools you never even knew you needed... so, You may be interested in our other listings.  Please remember 99% of the items I sell are used so they likely may have minor scratches or identificaiton numbers. 

Thank you!